Spa electric heater Balboa

This 3 kW heater will automatically heat the water to 40°C unless you install a thermostat elsewhere to set a lower temperature. It has a built-in pressure switch to detect water flow and a thermal cut-out at approximately 50°C as a safety feature in case other temperature control systems fail. It must be installed on the discharge side (see installation instructions) and can be mounted horizontally or vertically. The heater must be installed below the water level and in such a way that water can reach it when filling the spa and to avoid the risk of air pockets forming around the heater.
Dimensions:
Length without joints: 225mm
Height: 137mm
Length of power cable: 290mm
33mm internal diameter joints for 1'' pipes.
A reducer for connection to 32mm pipe is also supplied.
The heater is supplied with hydraulic connections and gaskets.